Computime Limited CTL3573 ユーザーズマニュアル
ZigBee- Ready RF Transceiver Module CTL3570/1/2/3
Copyright © 2011 Computime Limited. All rights reserved.
Rev. 3
4. Absolute Maximum Ratings
Parameter
Test Conditions
Min.
Max.
Unit
Regulator input voltage (VDD_PADS)
-0.3 +3.6
V
RF Input Power
(for max level for correct packet reception)
(for max level for correct packet reception)
RX signal into a lossless balun
+15 dBm
Voltage on any GPIO (PA[7:0], PB[7:0],
PC[7:0]), SWCLK, nRESET,
VREG_OUT
PC[7:0]), SWCLK, nRESET,
VREG_OUT
-0.3 VDD_PADS
+0.3
V
Voltage on any GPIO pin (PA4, PA5, PB5,
PB6, PB7, PC1), when used as an input to the
general purpose ADC with the low voltage
range selected
PB6, PB7, PC1), when used as an input to the
general purpose ADC with the low voltage
range selected
-0.3 2.0
V
Voltage on OSCA, OSCB, NC
-0.3 VDD_PADSA
+0.3
V
Storage temperature
-40 +140
°C
5. Recommended Operating Conditions
Parameter
Test Conditions
Min.
Typ.
Max.
Unit
Regulator input voltage (VDD_PADS)
2.7
3.6
①
V
Operating temperature range
0
+70
②
°C
6. Electrical Specifications
T=25℃, VCC = 3.0V, Fo =2450MHZ, if nothing else stated.
Parameter
Condition / Note
Min
Typ.
Max
Unit
Operating frequency
Programmable in 5MHz steps, 5 MHz
steps for IEEE 802.15.4 compliance
2.4 2.5
GHz
Number of channels
For IEEE 802.15.4 compliance
16
Channel spacing
For IEEE 802.15.4 compliance
5
MHz
Input/output impedance
50
Ohm
Frequency stability
+/-40
ppm
Transmit power
Programmable from firmware
-55
8
dBm
①
Regulator input voltage from 2.1 to 3.6V for module CTL3570 and CTL3572.
②
Operationg temperature range from -40 to 85°C for module CTL3570 and CTL3572.