Computime Limited AAHZT21 ユーザーズマニュアル
July 5, 2012
Page 19 of 49
66 8003 002-7
4.2 Installing a thermostat controller
Note:
The thermostat controller may not be sealed into a metal box.
4.2.1 Mounting a thermostat controller
The thermostat controller is designed to be installed
on a standard US or European single gang switch box.
Figure 10 shows the five screw holes on the back of the
thermostat controller.
on a standard US or European single gang switch box.
Figure 10 shows the five screw holes on the back of the
thermostat controller.
Note:
The thermostat controller may also be installed inside
an air handler as long as it in not encased in metal.
Figure 13
1.
The mounting bracket is attached using five screws
and the thermostat controller can then be snapped into
place on the mounting bracket as shown in Figure 14.
and the thermostat controller can then be snapped into
place on the mounting bracket as shown in Figure 14.
2.
Once the wiring harness is connected, it is best to
insert the thermostat controller on the bottom snaps
first; then press down on the top of the mounting
bracket as the top is snapped into place.
insert the thermostat controller on the bottom snaps
first; then press down on the top of the mounting
bracket as the top is snapped into place.
To remove a thermostat controller:
1.
Press down on the top of the mounting bracket to
release the snaps and pull the top of the thermostat
controller away from the wall; then lift up to
completely remove from the bracket.
release the snaps and pull the top of the thermostat
controller away from the wall; then lift up to
completely remove from the bracket.
Figure 14