Computime Limited AAHZT21 ユーザーズマニュアル
July 5, 2012
Page 25 of 49
66 8003 002-7
4.5 Commissioning the system
Before the devices can communicate, they must be joined to the ZigBee network. For detailed instructions and rules
on this network, see User manual Online option.
on this network, see User manual Online option.
Note:
The ZigBee network, including gateway and router locations, must first be specified by a qualified technician.
No online setup can be done until this step is completed.
4.5.1 Commissioning when thermostat controller is used
4.5.1.1 Joining the thermostat controller to the network
1.
In the
ZigBee Network
window of
SysMon, right click on the applicable
gateway/router and select
gateway/router and select
Permit
Joining
. The gateway/router is now
‘open’. It will remain in this status for
approximately 15 minutes or until a
forbid join command is executed.
approximately 15 minutes or until a
forbid join command is executed.
2.
With the gateway/router open,
plug the service cable into
the thermostat controller.
plug the service cable into
the thermostat controller.
Figure 19
3.
In the Orion Service software
(
(
Start/Programs/Orion Service/
Orion Service
), choose
Configure
device
in the left part of the window.
Let the tab
Thermostat
(default) be
open and click the
Discovery
button.
The thermostat controller will connect
to the open gateway/router.
to the open gateway/router.
Figure 20
4.
To see if the thermostat controller was able to join the network, click the
Check status
button in the
Configure
Device
section of Orion Service. If the joining was successful, the message ‘Device is online’ is shown.
5.
With the thermostat controller joined to its gateway/router, right click on the gateway/router in SysMon
and select
and select
Forbid Joining
.