Computime Limited AAHZT21 ユーザーズマニュアル
July 5, 2012
Page 28 of 49
66 8003 002-7
4.5.2.2 Joining the in-room devices to the thermostat
Next, the in-room devices must be joined to the thermostat, e.g. motion sensors and locks (or RF door switches,
if this is applicable).
if this is applicable).
1.
Plug the service cable
into the thermostat.
into the thermostat.
2.
Click the
Permit Join
button in
the
Configure device
section
of Orion Service; see Figure 24.
Note:
The thermostat will remain
open for 15 minutes or until a
Forbid Join
command is received.
Figure 24
3.
Once the thermostat has been
opened for joining, plug the
service cable into the motion sensor.
opened for joining, plug the
service cable into the motion sensor.
4.
Choose the
Motion sensor
tab in
the
Configure device
section of
Orion Service.
Click the
Discovery
button; see Figure 25.
Figure 25
5.
Wait a few seconds and then click
the
the
Check status
button in the
Motion sensor
tab of
Configure
device
; see Figure 26. If the device
has joined successfully, the message
‘Device is online’ is shown. If that
message is not displayed, wait a few
more seconds and check the status
again. If still offline, repeat the
discovery process.
‘Device is online’ is shown. If that
message is not displayed, wait a few
more seconds and check the status
again. If still offline, repeat the
discovery process.
Figure 26