Computime Limited AAHZT21 ユーザーズマニュアル
July 5, 2012
Page 35 of 49
66 8003 002-7
Appendix B: Firmware upgrade
At delivery, the thermostat and the motion sensor contain the correct module firmware. However, if a firmware
upgrade is needed at a later occasion, the service device with Orion Service is used. There are two ways to
download the module firmware to Orion Service:
upgrade is needed at a later occasion, the service device with Orion Service is used. There are two ways to
download the module firmware to Orion Service:
•
The first method is to save the module firmware on the VISIONLINE server, and then download
it from there to Orion Service
it from there to Orion Service
•
The second method is to upload the module firmware from e.g. a USB memory
Note:
Upgrading the
end node firmware in the thermostat may take several minutes.
Note:
If thermostat controller is applicable, and the firmware in this as well as in the thermostat should
be upgraded at the same time, it is recommended to start upgrading the thermostat controller first.
To first save the firmware on the VISIONLINE
server and then download it from there to
Orion Service:
server and then download it from there to
Orion Service:
1.
Go to
Tools/Module firmware
in the
VISIONLINE software. The dialog to
the right is shown.
the right is shown.
2.
Click
Read file
and browse to the
applicable module firmware file; tmf file.
3.
Mark the tmf file and click
Open
. The
tmf file will be read into the memory
and the tmf version will appear at
“Loaded version” in the lower left
corner of the
and the tmf version will appear at
“Loaded version” in the lower left
corner of the
Module firmware
dialog.