Computime Limited CT-EM2506 ユーザーズマニュアル

 

 ZigBee Ready RF Transceiver Modules

 

 

Computime Ltd.    All rights reserved 

Confidential 

Page 13 of 16  

 
The CT-EM2506 has been designed to meet all national regulations for World-wide use. 
Using the integrated antenna it conforms to FCC CFR 47 Part 15 (USA).   
 
This device complies with Part 15 of the FCC rules. Operation is subject to the 
following two conditions: (1) this device may not cause harmful interference, and 
(2) this device must accept any interference received, including interference that 
may cause undesired operation.   
 
The device CT-EM2506 carries FCC authorization and is marked with the FCC ID 
Number. Whilst any device into which this authorized module is installed will not normally 
be required to obtain FCC authorization, this does not preclude the possibility that some 
other form of authorization or testing may be required for the finished device.   
When the CT-EM2506 module is integrated inside another device/product, then the 
outside surface of that device/product must display a label referring to the enclosed 
module. This exterior label can use wording such as “Contains Transmitter Module 
FCC ID:

 

DI2CT-EM2506” or “Contains FCC ID: DI2CT-EM2506”

,

although any similar 

wording that expresses the same meaning may be used. 

 

 
To meet the Section 15.209 emission requirements in the restricted frequency 
bands of Section 15.205, the transceiver transmitter power for the CT-EM2506 
module needs to be reduced from the typical maximum setting on the upper 
channels(2480MHz).Maximum output power of Ember is -19dBm(Configured the 
output power of EM250 lower than -19dBm and enable the boost mode at the same 
time). 
 
 
FCC statement： 
If this equipment does cause harmful interference to radio or television reception, which 
can be determined by turning the equipment off and on, the user is encouraged to try to 
correct the interference by one or more of the following measures: 
—Reorient or relocate the receiving antenna. 
—Increase the separation between the equipment and receiver. 
—Connect the equipment into an outlet on a circuit different from that to which the 
receiver is connected. 
—Consult the dealer or an experienced radio/TV technician for help. 

Changes or modifications not expressly approved by the party responsible for compliance 
could void the user's authority to operate the equipment.