Computime Limited CT-EM2506 ユーザーズマニュアル
CT-EM2506
ZigBee Ready RF Transceiver Modules
Computime Ltd. All rights reserved
Confidential
Page 6 of 16
7. Introduction
The CT-EM2506 series of modules are specially designed for ZigBee application. They
provide a fast jump start design for system integrators or electronic designers wishing to
use ZigBee wireless technologies. The module contains qualified RF hardware and
enough processor power to run the EmberZNet stack or other ZigBee network stack
(depending on version), making it a powerful platform for building wireless networking
products. ZigBee Coordinators (ZC), ZigBee Routers (ZR), and ZigBee End Devices
(ZED) are all supported and are programmed onto the module together with a custom
application. Minimal RF design experience is needed to use CT-EM2506 modules.
provide a fast jump start design for system integrators or electronic designers wishing to
use ZigBee wireless technologies. The module contains qualified RF hardware and
enough processor power to run the EmberZNet stack or other ZigBee network stack
(depending on version), making it a powerful platform for building wireless networking
products. ZigBee Coordinators (ZC), ZigBee Routers (ZR), and ZigBee End Devices
(ZED) are all supported and are programmed onto the module together with a custom
application. Minimal RF design experience is needed to use CT-EM2506 modules.
8. Typical application block
Ember
EM250
Temp.
Sensor
Hum.
Sensor
VDD_PADS=2.7-3.6V
4 General A/D
Debug and
programming
interface
SIF PIN
MCU and/or
Peripheral
Equipment
SIF PIN
GPIO PIN
FEM