Computime Limited CT-EM2606 ユーザーズマニュアル
CT-EM2606 ZigBee Ready RF Transceiver Modules
Computime Ltd. All rights reserved
Confidential
13 / 16
17. Product Approvals
17.1 FCC Approvals
The CT-EM2606 has been designed to meet all national regulations for World-wide use.
Using the integrated antenna it conforms to FCC CFR 47 Part 15 (USA).
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
The device CT-EM2606 carries FCC authorization and is marked with the FCC ID
Number. Whilst any device into which this authorized module is installed will not normally
be required to obtain FCC authorization, this does not preclude the possibility that some
other form of authorization or testing may be required for the finished device.
When the CT-EM2606 module is integrated inside another device/product, then the
outside surface of that device/product must display a label referring to the enclosed
module. This exterior label can use wording such as “Contains Transmitter Module
FCC ID:
The CT-EM2606 has been designed to meet all national regulations for World-wide use.
Using the integrated antenna it conforms to FCC CFR 47 Part 15 (USA).
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
The device CT-EM2606 carries FCC authorization and is marked with the FCC ID
Number. Whilst any device into which this authorized module is installed will not normally
be required to obtain FCC authorization, this does not preclude the possibility that some
other form of authorization or testing may be required for the finished device.
When the CT-EM2606 module is integrated inside another device/product, then the
outside surface of that device/product must display a label referring to the enclosed
module. This exterior label can use wording such as “Contains Transmitter Module
FCC ID:
DICT-EM2606” or “Contains FCC ID: DICT-EM2606”
,
although any similar
wording that expresses the same meaning may be used.
To meet the Section 15.209 emission requirements in the restricted frequency
bands of Section 15.205, the transceiver transmitter power for the CT-EM2606
module needs to be reduced from the typical maximum setting on the upper two
channels (2475 MHz and 2480 MHz). Maximum values are TBD.
bands of Section 15.205, the transceiver transmitter power for the CT-EM2606
module needs to be reduced from the typical maximum setting on the upper two
channels (2475 MHz and 2480 MHz). Maximum values are TBD.
FCC statement：
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
could void the user's authority to operate the equipment.