Computime Limited RCSIT-TX ユーザーズマニュアル

 

 

50D0098 RCSITE Installation & Operating Manual                                
Rel 0  Dec 2005 

   Page 7 of 10 

                                     Ambient Technologies 

           A Division Of  Monessen Hearth Systems  

 

 
Child-Proof Protection:  
 

1. Press and hold the ON and OFF buttons simultaneously for 3 seconds to enter 

childproof mode as shown in this picture. 

2. The transmitter will not send a signal again until childproof mode is deactivated by 

pressing the ON and OFF buttons simultaneously for 3 seconds to exit childproof 
mode and the Childproof indicator disappears from LCD.   

 
 
 
 
Transmitter Thermal Shutdown: 
 

1. If transmitter measures a room temperature exceeding 99 degrees Fahrenheit, the 

LCD will display "HI" and the transmitter will turn off the appliance. 

2. Transmitter will not function until the room temperature has dropped below 99 

degree Fahrenheit.  If transmitter measures a room temperature less than 40 
degrees Fahrenheit, the LCD will display “LO” and NO SIGNAL will be sent to 
turn on the appliance.  

 
 

 

Slide Switch: 
 

1.  ON position: the main burner will ignite , the flame height is max; otherwise just burner will ignite until the 

slide switch is placed in the OFF or RS position to turn burner off. 

2.  RS position: the system will only operate if the remote receiver receives a signal from the transmitter. 
3.  OFF position, the system is off. The slide switch should be placed in the OFF position if you will be 

away for an extended period of time.   If the remote receiver is mounted out of children’

s reach, the OFF 

position also functions as a safety device by both turning the system off and rendering the receiver 
inoperable. 

Optional 6 Hour Shutdown: 
 

1.  The receiver comes preset from the factory with a 6 hour shutdown from its last ON or flamer lower 

operation.  This is done to prevent the appliance from continuing to run if  unattended. 

2.  You may disable this feature if you wish.  To disable, change the receiver privacy (DIP) switch #1 ONLY 

to the OFF position.  Make sure the transmitter privacy (DIP) switches are set the same as the receiver.  
Follow the instructions on how to set the privacy (DIP) switch setting. 

 
Optional Wall Cover Plate: 
 

 Receiver snaps into wall cover plate. The wall plate is mo unted by using 2 screws provided.