Computime Limited RCSITE-TX ユーザーズマニュアル
50D0111
RCSITEA Installation & Operating Manual
Rel 1.0 April 2009
Page 2 of 10
Ambient Technologies
A Division Of Monessen Hearth Systems
• Quick Disconnect Wiring Assembly
• Reset Button for transmitter
WARNING
Important Safety Information
• Read this manual thoroughly prior to installing, programming or operating any remote control.
• This remote control system is designed for use with a millivolt gas valve system with blower. Do not use
this remote control system on applications with voltages above 24 Volts AC/DC and 1 amp current.
• This remote control system requires three (3) “AAA” alkaline batteries to power the transmitter. The
receiver is powered by external AC Adapter.
• Wiring must conform to appliance requirement and building codes/ordinances as required by local and
national code authorities having jurisdiction.
• Do not short (or jumper) across the gas valve terminals to test the remote control installation. This could
damage the unit and void the warranty.
• This remote control system should only be used as described in this manual. Any other use is not
recommended and will void the warranty.
NOTE
Due to the sensitive temperature monitoring components in the transmitter, it is necessary to
allow the transmitter to stabilize to room temperature before accurate room temperatures are
displayed. If the transmitter is activated from a severe cold condition, allow 15 minutes for
accurate temperature readings to appear on the LCD display.
allow the transmitter to stabilize to room temperature before accurate room temperatures are
displayed. If the transmitter is activated from a severe cold condition, allow 15 minutes for
accurate temperature readings to appear on the LCD display.
W
A
RNING
Turn appliance OFF and allow to cool before installing or servicing. DO NOT connect
110-120 VAC wiring to the milli-volt gas control valve. The remote operator must be installed
exactly as outlined in these instructions. Read all instructions completely before attempting
installation. Follow instructions carefully during installation. Any modification of
components will void the warranty and may cause a fire hazard.
110-120 VAC wiring to the milli-volt gas control valve. The remote operator must be installed
exactly as outlined in these instructions. Read all instructions completely before attempting
installation. Follow instructions carefully during installation. Any modification of
components will void the warranty and may cause a fire hazard.
W
A
RNING
Turn appliance OFF (at the appliance or remote receiver) if you are away from your house
for an extended period of time. Never leave anything on top of the surface of the transmitter.
for an extended period of time. Never leave anything on top of the surface of the transmitter.
INSTALLATIONS
Remote Receiver:
The remote receiver may be installed in the appliance per the appliance homeowner’s manual. Refer to the
Homeowner’s Manual for special installation instructions. Failure to follow the installation instructions found
in the appropriate Homeowner’s Manual will void the warranty and may cause a fire hazard.