Computime Limited TS-TX ユーザーズマニュアル
MHSC
Touch Screen Full Function Signature Command Operating Instructions
Touch Screen Full Function Signature Command Operating Instructions
Page:
7
Light Brightness Control
The light brightness control function is used to adjust the brightness of the light
bulbs connected to the AC module on the Signature Command System. There
are four light brightness levels defined: Off, Low, Medium and High.
bulbs connected to the AC module on the Signature Command System. There
are four light brightness levels defined: Off, Low, Medium and High.
1. Press the LIGHT button to enter the light brightness control mode. The
LIGHT icon will start flashing.
2. Press the ON/up and OFF/down buttons to increase/decrease the light
brightness (Off-Low-Medium-High).
3. Press the light button again to confirm the setting. The new setting will be
transmitted to the receiver.
4. After the signal is sent, the ON/up and OFF/down buttons become flame
height controller again.
5. When the light button is flashing, slide up and down on the arrow buttons
will turn the light brightness to High or Off derictly without pressing the
light button again to confirm.
light button again to confirm.
AUX Control
The AUX control function only exists on RFSC. It is used to turn on or turn off the auxiliary connected to
the AC module of the Signature Command System. Press the AUX button to to turn on or turn off the
auxiliary.
the AC module of the Signature Command System. Press the AUX button to to turn on or turn off the
auxiliary.
1. When the auxiliary is turned on, the icon will become solid text and the “ON” icon will appear below
the “AUX” icon.
2. When the auxiliary is turned off, the icon will become hollow text and the “ON” icon will disappear.
Setting up Blank Screen or Constant Display in Idle
There is an option to set up how the LCD displays and
functions when the transmitter is in idle. There are two
choices:
functions when the transmitter is in idle. There are two
choices:
1. A) Mode. When the transmitter is in idle, the icons in the
“touch area” (timer, thermostat, blower, light, and AUX)
will disappear, as shown in the figure on the left. When
any of the touch buttons is pressed, those icons will
appear and ready to operate.
will disappear, as shown in the figure on the left. When
any of the touch buttons is pressed, those icons will
appear and ready to operate.
2. B) Mode. The transmitter always displays all available
icons showing current status of timer, thermostat, blower,
light, and AUX, as shown in the figure on the right.
light, and AUX, as shown in the figure on the right.
Press TIMER and THERMO buttons at the same time to toggle between A) and B).
1. When the current setting is B), pressing TIMER button and THERMO button at the same time will
1. When the current setting is B), pressing TIMER button and THERMO button at the same time will
switch to A) Mode. The touch area icons will disappear.
2. When the current setting is A), touch any place in the touch area to bring up the icons then press
TIMER button and THERMO button at the same time. The backlight will flash once to indicate that
the setting has changed to B).
the setting has changed to B).