Mindray DS USA Inc. NG1400AP ユーザーズマニュアル

ページ / 69
NetGuard™ Operating Instructions
0070-10-0678-01
v
Warnings, Precautions and Notes
Introduction
Cautions
CAUTION:
For proper operation use only with UL agency approved 
ethernet cables. 
CAUTION:
For proper operation, do not use the equipment with a 
frayed or damaged power cord or ethernet cable.
CAUTION:
Do not use a damaged or broken unit or accessory. 
CAUTION:
For proper operation never place fluids on top of the server. 
In case of accidental spillage, wipe clean immediately and 
have the system serviced to ensure no hazard exists.
CAUTION:
The LEDs on the device may not be clearly visible under 
brightly lit conditions. The lighting should be adjusted to 
ensure that all LED indicators are clearly visible.
CAUTION:
The server and terminal for this device must only be setup 
by qualified Datascope personnel.
CAUTION:
Do not block the terminal speakers. Set the volume levels to 
ensure that alarms can be heard at all times.
CAUTION:
Speaker volume should be set high enough to hear an 
alarm above ambient noises. 
CAUTION:
The NetGuard device may not function properly, if it was 
subjected to extreme mechanical forces. 
CAUTION:
To prevent the possible overlap of Trend data, a patient 
should be discharged before another patient is admitted to 
the same bed. 
CAUTION:
Discharging a patient should occur in the following order: 
Discharge the patient from the bed, connect the device to the 
new patient, and then assign the patient to a new bed. 
CAUTION:
The NetGuard device should not be used when the Electro 
Surgical Unit (ESU) is active. 
CAUTION:
The NetGuard device may not function if the batteries 
installed in the device are corroded. 
CAUTION:
Do not incinerate the NetGuard device. Possible explosion 
may occur because of the internal battery. 
CAUTION:
To avoid possible interference with other facility devices, 
use the correct AC cord for all equipment installed on the 
NetGuard network. 
CAUTION:
It is recommended that password protected screen savers 
be disabled after the NetGuard terminal software 
installation. Use of screen savers may degrade the 
performance of NetGuard software application.