Mindray DS USA Inc. VT0190-00000 ユーザーズマニュアル
2.3 Disconnect the cable from the TIM and replace the antenna network cable.
2.4 Detach the SMA to BNC cable from the telepak. Attach a SMA to SMA cable to
2.4 Detach the SMA to BNC cable from the telepak. Attach a SMA to SMA cable to
the telepak with the 30 dB attenuator. Attach the other end of this cable to an
antenna on the repeaters “A” leg by removing the antenna stick and attaching the
SMA cable.
antenna on the repeaters “A” leg by removing the antenna stick and attaching the
SMA cable.
2.5 Adjust the rotary switch the “A” leg of the cable repeater 0670-00-0776-01 board.
Set the gain on the cable repeater to the reading from the TIM with the telepak
attached minus 1 to 2 dB.
Note: set both switches on the repeater board to the same settings.
attached minus 1 to 2 dB.
Note: set both switches on the repeater board to the same settings.
2.6 Switch the antenna network “A” leg and “B” leg.
2.7 Attach the other end of this cable to an antenna on the repeaters “B leg.
2.8 Adjust the rotary switch the “B leg of the cable repeater 0670-00-0776-01 board.
2.7 Attach the other end of this cable to an antenna on the repeaters “B leg.
2.8 Adjust the rotary switch the “B leg of the cable repeater 0670-00-0776-01 board.
Set the gain on the cable repeater to the reading from the TIM with the telepak
attached minus 1 to 2 dB.
Note: set both switches on the repeater board to the same settings.
attached minus 1 to 2 dB.
Note: set both switches on the repeater board to the same settings.
2.9 Switch the antenna network “A” leg and “B” leg back.
2.10 Detach the telepak and replace the antenna stick.
2.10 Detach the telepak and replace the antenna stick.
Perform the verification walk around.