Kenwood USA Corporation 29473120 ユーザーズマニュアル
R
ADIO
F
REQUENCY
S
AFETY
I
NFORMATION
This KENWOOD transceiver has been tested and complies with the standards
listed below, in regards to Radio Frequency (RF) energy and electromagnetic
energy (EME) generated by the transceiver.
listed below, in regards to Radio Frequency (RF) energy and electromagnetic
energy (EME) generated by the transceiver.
•
FCC RF exposure limits for
Occupational Use Only
•
FCC OET Bulletin 65 Edition 97-01 Supplement C
•
American National Standards Institute (C95.1 – 1992)
•
American National Standards Institute (C95.3 – 1992)
This KENWOOD transceiver generates RF EME while transmitting. The transceiver has been designed
for and is classified as
for and is classified as
Occupational Use Only
. This means you can use the transceiver only if you are
aware of the hazards of operating a transceiver and are familiar in ways to minimize these hazards. This
transceiver is not intended for use by the general public in uncontrolled environments.
transceiver is not intended for use by the general public in uncontrolled environments.
The following list provides you with the information required to ensure you are
aware of RF exposure and of how to operate this transceiver so that the FCC RF
exposure limitations are not exceeded.
aware of RF exposure and of how to operate this transceiver so that the FCC RF
exposure limitations are not exceeded.
•
While transmitting (holding the PTT switch), always keep the antenna at least
3 cm (1 3/16 inches) from your body, as well as from any bystanders.
3 cm (1 3/16 inches) from your body, as well as from any bystanders.
•
Do not transmit for more than 50% of the total transceiver use time; transmitting
over 50% of the total use time may exceed the limits in accordance to the FCC
RF exposure requirements. Nominal transceiver operation is 5% transmission
time, 5% reception time, and 90% stand-by time.
over 50% of the total use time may exceed the limits in accordance to the FCC
RF exposure requirements. Nominal transceiver operation is 5% transmission
time, 5% reception time, and 90% stand-by time.
•
Use only the specified antenna for this transceiver; this may be either the
antenna provided with the transceiver or another antenna authorized by the
manufacturer.
antenna provided with the transceiver or another antenna authorized by the
manufacturer.
•
Use only KENWOOD authorized accessories (antennas, battery packs, belt
clips, etc.):
clips, etc.):
KRA-5 antenna, KB8-8DS optional swivel belt loop, J29-0624-03 supplied belt clip
To ensure that your exposure to RF EME is within the FCC limits for occupational use, you must observe
and adhere to the above points.
and adhere to the above points.
Electromagnetic Interference Compatibility
Electronic devices are susceptible to electromagnetic interference (EMI) if they are
not adequately shielded or designed for electromagnetic compatibility. Because this
transceiver generates RF energy, it can cause interference to such equipment.
not adequately shielded or designed for electromagnetic compatibility. Because this
transceiver generates RF energy, it can cause interference to such equipment.
•
Turn OFF your transceiver where signs are posted to do so. Hospitals and
health care facilities use equipment that is sensitive to electromagnetic radiation.
health care facilities use equipment that is sensitive to electromagnetic radiation.
•
Turn OFF your transceiver while on board an aircraft when so instructed. Use of the
transceiver must be in accordance with airline regulations and/or crew instructions.
transceiver must be in accordance with airline regulations and/or crew instructions.