RELM Communications Inc RPV599A ユーザーズマニュアル
User Manual
For RPV599A Programming Software
Version 1.00
² Introduction
RPV599A Programming Software described in this user manual is applicable to RPV599A
Transceiver. This software is mainly used for writing data to your transceiver or reading data from
your transceiver via your computer and copyrighted by Relm Corporation.
Transceiver. This software is mainly used for writing data to your transceiver or reading data from
your transceiver via your computer and copyrighted by Relm Corporation.
² Statement
“It is forbidden to transmit this device on marine frequencies 156.10 MHz (Marine Channel 02), 156.20
MHZ (Marine Channels 04 and 04A), 156.025 MHz (Marine Channel 60), and 156.125 MHz (Marine
Channel 62).”
Programming software, accessories, and procedures are issued only to authorized distributors and
repair facilities. The radio cannot be programmed for any frequency change, including channel
spacing (12.5/15 kHz vs. 25/30 kHz), by a user in the field.
MHZ (Marine Channels 04 and 04A), 156.025 MHz (Marine Channel 60), and 156.125 MHz (Marine
Channel 62).”
Programming software, accessories, and procedures are issued only to authorized distributors and
repair facilities. The radio cannot be programmed for any frequency change, including channel
spacing (12.5/15 kHz vs. 25/30 kHz), by a user in the field.
² Install Software
In your disk, which is presented to you together with your transceiver, you can see one setup file of
our software, which is named by RPV599ASetup.EXE. By clicking the setup file, installing will run
automatically. During the installing process, you can do something according to the setup wizard.
When finished, the software has been installed in your computer.
our software, which is named by RPV599ASetup.EXE. By clicking the setup file, installing will run
automatically. During the installing process, you can do something according to the setup wizard.
When finished, the software has been installed in your computer.
² Connect a Cable
After installing the software, but how to use it with your transceiver
You will have a cable that connects your computer with your transceiver. You can connect your
computer to your transceiver according to the following steps.
Insert one end of the cable to the serial port (COM1 or COM2) of your computer, the other end to
the Speaker/Microphone “ port of the transceiver. Before operating the transceiver, you are
required to open the power switch of the transceiver.
You will have a cable that connects your computer with your transceiver. You can connect your
computer to your transceiver according to the following steps.
Insert one end of the cable to the serial port (COM1 or COM2) of your computer, the other end to
the Speaker/Microphone “ port of the transceiver. Before operating the transceiver, you are
required to open the power switch of the transceiver.
² Run Software
There is a shortcut to it on your computer Desktop and Program Manager group. Execute this
shortcut “RPV599A Programming Software“ to run the program. The Main Interface displays as
follow.
shortcut “RPV599A Programming Software“ to run the program. The Main Interface displays as
follow.
Figure 1
² Select Communication Port
When changing the connecting serial port, you must select the corresponding communication
settings. To select a different communication port, click Communication of Option Menu and set a
settings. To select a different communication port, click Communication of Option Menu and set a