Raytheon Anschuetz GmbH High Seas Products MTX5 ユーザーズマニュアル
Chapter 1: Overview
1
Chapter 1: Overview
1.1 Introduction
This handbook provides instructions to assist you in the installation and set up
of the following radar scanners:
of the following radar scanners:
18" Radome Scanner
24" Radome Scanner
48" Open Array Scanner
24" Radome Scanner
48" Open Array Scanner
A typical Pathfinder Radar system is illustrated below.
NMEA
SeaTalk
Display Unit
Distribution Panel
D4288-2
Scanner
12/24V Supply
12V Supply
12V Supply
Junction
Box
GPS
Compass
CAUTION
Do not use the 48" Open Array Scanner with an SL70 or Autohelm 7”
display unit. Failure to observe this may result in permanent damage to
these display units.
Do not use the 48" Open Array Scanner with an SL70 or Autohelm 7”
display unit. Failure to observe this may result in permanent damage to
these display units.
This handbook is divided into three chapters as follows:
Chapter One provides an overview of the scanner installation. It includes
sections on Unpacking and Inspecting the Components, Selecting the Scanner
Site and a description of the Cable Runs.
sections on Unpacking and Inspecting the Components, Selecting the Scanner
Site and a description of the Cable Runs.
Chapter Two provides detailed instructions on how to mount and connect each
type of scanner.
type of scanner.
Chapter Three provides instructions on how to perform the system checks,
alignment and adjustments.
alignment and adjustments.
154_2c1.p65
13/05/99, 13:17
1