Multi-Tech Systems 92U13A16854 ユーザーズマニュアル

ページ / 25
REGULATORY INFORMATION
Regulatory Information
Industry Canada and FCC
This device complies with Industry Canada licence-exempt RSS standard(s) and part 15 of the FCC rules. Operation
is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the
device.
Cet appareil est conforme avec Industrie Canada RSS exemptes de licence standard (s) et la partie 15 des règles de
la FCC. Son fonctionnement est soumis aux deux conditions suivantes:
1. l'appareil ne doit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
Warning:
Changes or modifications to this radio device not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note:
In Wi-Fi operation, the modem cannot operate on Channels 12, 13, or 14 due to FCC regulations.
FCC and IC Antenna Requirements Toward License Exempt Radio
Transmitters (Bluetooth/Wlan)
The license-exempt Blutooth/WLAN radio transmitter contained in this equipment may only be operated with an
antenna of a type, a maximum gain and the required antenna impedance as approved and specified below. To
reduce potential radio interference to other users, choose the antenna type and it's gain so that the equivalent
isotropically radiated power (EIRP) is not more than that necessary for successful communication.
Requirements for Cellular Antennas with regard to FCC/IC
Compliance
There cannot be any alteration to the authorized antenna system. The antenna system must maintain the same
specifications. The antenna must be the same type, with similar in-band and out-of-band radiation patterns. This
device has been designed to operate with the antennas listed below and having a maximum gain for 850 Mhz of <=
6.4 dBi , for 1700 Mhz of <= 6.5 dBi, and for 1900 Mhz of <= 3 dBi. Antennas not included in this list or that have a
gain greater than specified are strictly prohibited for use with this device. The required antenna impedance is 50
ohms.
EMC, Safety, and R&TTE Directive Compliance
The CE mark is affixed to this product to confirm compliance with the following European Community Directives:
20
MultiConnect
®
rCell 100 Series Router User Guide