Motorola Solutions Inc. 92FT4915 ユーザーズマニュアル

6878215A01

2-44

 Speaker

 This configuration is only applicable for O2 Control Heads.

You can disable the internal speaker of your radio by following the instructions below.

Use the following procedure to disassemble your radio:

1. Unplug power, antenna, microphone and all accessories connections. If the radio is a 

remote-mount radio, disconnect the remote-mount control cable from the front of the 
transceiver.

2. Remove the four screws found on the control head with a Torx T-20 bit as shown in

 

Figure 2-57

. Discard the screws.

3. Firmly grasp the front panel of the control head. Carefully remove the front housing assembly 

from the back housing assembly as shown in 

Figure 2-58

. Note the position of the attached 

flex and do not pull on it excessively.