VeriFone UX401CTLS ユーザーズマニュアル

*DOC159-071-EN-A*

c

 2015 Verifone, Inc. All rights reserved. 

2099 Gateway Place, Suite 600

San Jose CA 95110

Tel: 800 Verifone (837-4366)

www.verifone.com

Verifone Part Number: DOC159-071-EN-A

 

Revision A.2

The reference input power rating for the UX301 is 8V DC to 43V DC.

Use of an external power supply is 12V DC, 3.3A or 24V DC, 3.75A.

Do not install this device near electrical appliances or other devices that cause excessive voltage fluctuations or 
emit electrical noise (for example: air conditioners, neon signs, electric motors, high-frequency or magnetic 
security devices).

WARNING!This device contains sensitive electronic components that can be permanently damaged if exposed 

to excessive shock, electrical interference or vibration.

Do not, under any circumstances, attempt any service, adjustments, or repairs on this equipment. Instead, 
contact your local Verifone distributor or service provider for assistance. Failure to comply may void the product 
warranty.

Carefully inspect the shipping carton and its contents for any damage. If the UX301 or any product component 
appears damaged or tampered, immediately notify the shipping company and your Verifone distributor or service 
provider.

Do not use a device that has been damaged or tampered with.

Never use thinner, trichloroethylene, or ketone-based solvents to clean the device — they may deteriorate the 
plastic and rubber parts. For best results, use a clean cloth dampened with water and mild soap. To remove 
stubborn stains, use alcohol or an alcohol-based cleaner.

The following product has been tested and certified as compliant with the regulations and guidelines set forth in 
Part 15 of FCC Rules:

Manufacturer: Verifone, Inc.
Brand, Model: UX301

This device complies with the limits for a Class B digital device as specified in Part 15 of FCC Rules which provide reasonable 

protection against harmful interference in a residential area.

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

This device may not cause harmful interference; and,

This device must accept any interference received, including interference that may cause undesired operation. 

This equipment generates and uses radio frequency energy, and if not installed and used in accordance with the instructions, may 

cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular 

installation. 

In the unlikely event that there is interference to radio or television reception (which can be determined by turning the equipment off 

and on), the user is encouraged to try to correct the interference by one or more of the following measures:

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•

Consult with the dealer or ask an experienced radio/TV technician for help.

Any changes or modifications to this equipment not expressly approved by Verifone could void the user’s authority to operate this 

equipment. The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or 

transmitter. Use of a shielded interface cable is required to comply with the Class B limits of Part 15 of FCC Rules.

This device was verified for RF exposure. To comply with Council Recommendation 1999/519/EC, IC RSS-102, and FCC RF 
exposure requirements, a minimum separation distance of 20 cm must be maintained between the user's body and the device, 
including the antenna. Any metallic components should be far from this device. Conditions that do not meet these requirements 
may not comply with Council Recommendation 1999/519/EC, IC RSS-102 and FCC RF exposure requirements and should be 
avoided.

To comply with the FCC RF exposure compliance requirements, make sure to use only the antenna that is included with the device. 
This device and its antenna must not be in the same location or operating in the same area in conjunction with any other antenna or 
transmitter.

PCI SSC’s approval only applies to PEDs that are identical to the PED tested by a PCI Security Standards Council recognized 
laboratory. If any aspect of the PED is different from that which was tested by the laboratory - even if the PED conforms to the basic 
product description contained in the letter, then the PED model should not be considered approved, nor promoted as approved. For 
example, if a PED contains firmware, software, or physical construction that has the same name or model number as those tested 
by the laboratory, but in fact are not identical to those PED samples tested by the laboratory, then the PED should not be 
considered or promoted as approved.

No vendor or other third party may refer to a PED as “PCI Approved,” nor otherwise state or imply that PCI SSC has, in whole or 
part, approved any aspect of a vendor or its PEDs, except to the extent and subject to the terms and restrictions expressly set forth 
in a written agreement with PCI SSC, or in an approval letter. All other references to PCI SSC’s approval are strictly and actively 
prohibited by PCI SSC.

When granted, an approval is provided by PCI SSC to ensure certain security and operational characteristics important to the 
achievement of PCI SSC’s goals, but the approval does not under any circumstances include any endorsement or warranty 
regarding the functionality, quality, or performance of any particular product or service. PCI SSC does not warrant any products or 
services provided by third parties. Approval does not, under any circumstances, include or imply any product warranties from PCI 
SSC, including, without limitation, any implied warranties of merchantability, fitness for purpose or non-infringement, all of which are 
expressly disclaimed by PCI SSC. All rights and remedies regarding products and services, which have received an approval, shall 
be provided by the party providing such products or services, and not by PCI SSC or the payment brand participants.

This equipment operates on a secondary basis. It is not entitled to protection from harmful interference, even for stations of the 
same type, and may not cause interference to systems operating on a primary basis.

UNIT MUST BE RECYCLED OR DISPOSED OF PROPERLY
For proper disposal instructions go to http://recycle.verifone.com/Please retain this sheet for future reference.

continued on rear cover