VeriFone V400M4GWW ユーザーズマニュアル

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two 

conditions: (1) This device may not cause harmful interference, and (2) this device must accept any 

interference received, including interference that may cause undesired operation. 

 

This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to Part 15 of the FCC Rules.    These limits are designed to provide reasonable protection 

against harmful interference in a residential installation. This equipment generates, uses and can 

radiate radio frequency energy and, if not installed and used in accordance with the instructions, 

may cause harmful interference to radio communications.  However, there is no guarantee that 

interference will not occur in a particular installation.  If this equipment does cause harmful 

interference to radio or television reception, which can be determined by turning the equipment off 

and on, the user is encouraged to try to correct the interference by one of the following measures: 

 
z  Reorient or relocate the receiving antenna. 
z  Increase the separation between the equipment and receiver. 
z  Connect the equipment into an outlet on a circuit different from that 

to which the receiver is connected. 

z  Consult the dealer or an experienced radio/TV technician for help. 

 

FCC Caution: 
¾  Any changes or modifications not expressly approved by the party responsible for compliance 

could void the user's authority to operate this equipment. 

¾  This transmitter must not be co-located or operating in conjunction with any other antenna or 

transmitter. 

Radiation Exposure Statement: 

This device meets the government’s requirements for exposure to radio waves. 

This device is designed and manufactured not to exceed the emission limits for exposure to radio 

frequency (RF) energy set by the Federal Communications Commission of the U.S. Government. 

The exposure standard for wireless device employs a unit of measurement known as the Specific 

Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. 

*

Tests for SAR are conducted 

using standard operating positions accepted by the FCC with the device transmitting at its highest 

certified power level in all tested frequency bands.