VeriFone VX670WIFI ユーザーズマニュアル

c

 2006 VeriFone, Inc. All rights reserved. 

2099 Gateway Place, Suite 600

San Jose CA 95110

Tel: 800 VeriFone (837-4366)

www.verifone.com

VeriFone Part Number: 24000

 

Revision A.3

*24000*

Before you connect the terminal power pack to an electrical outlet, check that the on/off power switch on the terminal is off. If the terminal 
does not have an on/off switch, check that the power cable connector is removed from the terminal’s power port.

or 

When connecting the terminal to a power pack, always connect the plug of the power pack to an electrical wall outlet first. Then connect 
the power cable to the terminal’s power port.

The power pack is rated as follows:

Input Voltage: 100 - 240 V AC, 50/60 Hz

Output Voltage: 12 V DC, 2 A

The AC adapter is designed to ensure your personal safety and to be compatible with this equipment. Please follow these guidelines:

•

Do not use the adapter in a high moisture environment. Never touch the adapter when your hands or feet are wet.

•

Allow adequate ventilation around the adapter. Avoid locations with restricted airflow.

•

Connect the adapter to a proper power source. The voltage and grounding requirements are found on the product case and/or 
packaging.

•

Do not use the adapter if the cord becomes damaged.

•

Do not attempt to service the adapter. There are no serviceable parts inside. Replace the unit if it is damaged or exposed to excess 
moisture.

Some peripherals require a separate power source. Before connecting a check reader or similar device, remove the power cable 
connector from the terminal’s power port.

Before connecting any peripheral device, turn off power to the terminal and check that the power cable connector is removed from the 
terminal’s power port. Turn on power only after you are finished connecting the peripheral device(s). For complete information about 
peripheral installation and use, please refer to the user documentation supplied with those devices.

Caution: To reduce the risk of fire, use only No. 26 AWG or larger UL Listed or CSA Certified Telecommunication Line Cord.

Disconnecting power during a transaction may cause transaction data files that are not yet stored in terminal memory to be lost.

CAUTION: Due to risk of electrical shock or terminal damage, do not use the terminal near water, including a bathtub, wash bowl, kitchen 
sink or laundry tub, in a wet basement, or near a swimming pool. Also, avoid using this product during electrical storms.

Avoid locations near electrical appliances or other devices that cause excessive voltage fluctuations or emit electrical noise (for example, 
air conditioners, neon signs, high-frequency or magnetic security devices, or electric motors).

Do not, under any circumstances, attempt any service, adjustments, or repairs on this equipment. Instead, contact your local VeriFone 
distributor or service provider for assistance. Failure to comply may void the product warranty.

Do not plug the power pack into an outdoor outlet or operate the terminal outdoors. It is not waterproof or dustproof, and is for indoor use 
only. Any damage to the unit from exposure to rain or dust may void your warranty.

Do not use the terminal where there is high heat, dust, humidity, moisture, or caustic chemicals or oils. Keep the terminal away from direct 
sunlight and anything that radiates heat, such as a stove or a motor.

The following device has been tested and certified as compliant with the regulations and guidelines set forth in Part 68 of FCC 
Rules:

Manufacturer: VeriFone, Inc.
Brand, Model: V

670

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not 
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause 
undesired operation. 

This equipment complies with Part 68 of the FCC Rules. On the modem board inside full featured base stations is a label that 
contains, among other information, the FCC registration number and ringer equivalence number (REN) for this equipment. If 
requested, this information may be provided to the telephone company.

The REN is used to determine the quantity of devices that may be connected to the telephone line. Excessive RENs on the 
telephone line may result in the device not ringing in response to an incoming call. In most, but not all areas, the sum of the RENs 
should not exceed five (5.0). To be certain of the number of devices that may be connected to the line, as determined by the total 
RENs, contact the telephone company to determine the maximum RENs for the calling area.

This terminal cannot be used on telephone-company-provided coin service. Connection to Party Line Service is subject to state 
tariffs.

This equipment uses the following USOC jacks: (RJ11C).

An FCC-compliant telephone cord and modular plug is provided with this equipment. This equipment is designed to be connected 
to the telephone network or premises wiring using a compatible modular jack that is Part 68 compliant.

If this equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary 
discontinuance of service may be required. If advance notice is not practical, the telephone company will notify the customer as 
soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary.

The telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the operation of 
this equipment. If this happens, the telephone company will provide advance notice in order for you to make the necessary 
modifications to maintain uninterrupted service.

If trouble is experienced with this equipment, please contact VeriFone, or your local VeriFone distributor or service center in the 
U.S.A. for repair and/or warrant information. If the trouble is causing harm to the telephone network, the telephone company may 
request you to remove this equipment from the network until the problem is resolved. No repairs can be done by a customer on this 
equipment.

It is recommended that the customer install an AC surge arrestor in the AC outlet to which this device is connected. This is to avoid 
damage to the equipment caused by local lightning strikes and other electrical surges.

This device was verified for RF exposure. To comply with Council Recommendation 1999/519/EC and FCC RF exposure 
requirements, a minimum separation distance of 20 cm must be maintained between the user’s body and the device, including the 
antenna. Any metallic components should be far from this device. Conditions that do not meet these requirements may not comply 
with Council Recommendation 1999/519/EC and FCC RF exposure requirements and should be avoided.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be 
installed and operated with a minimum distance of 2.5cm between the radiator and your body. For additional compliance 
information, please reference FCC ID: MXF-F910131.

SAR compliance for body worn operating configurations is limited to the specific accessories that have no metallic component in the 
assembly. The highest reported SAR values under the FCC ID B32OMNI56XXG are: PMS modes (Part 22) – Body-worn 0.753mW/g, 
PCS mode (Part 24) - Body-worn: 0.564mW/g.

Please switch off and do not operate the equipment when in an area with a potentially explosive atmosphere, such as refueling points, 
fuel depots or storage areas, chemical plants, and blasting operations.

UNIT MUST BE RECYCLED OR DISPOSED OF PROPERLY
For proper disposal instructions go to http://recycle.verifone.com/

Please retain this sheet for future reference.