Porta Phone Company Inc BPK1015 ユーザーズマニュアル

 

 

Page 3 

If you go back to the located range again, the communication link will restore, also the “In use” LED will 
blanking steadily. 
Note: your talk will be cut without any audible warning tone if you are in a talk and out of the located range. 
 
Registration 
The headset and base shall be factory pre-registered with the identification digital security codes, which are 
stored into the non-volatile memory, so that your headset shall be ready for working after out-of-box. However, 
your headset shall also has a procedure to allow you to re-do the registration operation in case of the link is lost 
accidentally. 
-press  

 

key 3 times,

 

Press and hold  key for 3 seconds on the headset “In use” LED is ON, your headset 

entered the registration mode 
-Press and hold SUB key for 3 seconds on the base until “SUB” LED is flashlight, the base also entered the 
registration mode. 
Note: SUB key A1-A4 is for channel A station, B1-B4 is for channel B station. 
-About 5-10 seconds the headset “In use” LED is OFF and following to ON, that means the headset has located 
the base, and the base until “SUB” LED is OFF and following to ON. 
-If the headset does not locate the base, the headset “In use” LED will be blink after 15 seconds and it will 
return to the non-located mode. Try again and check that you are not in the interference environment   
Note: your base can register up to 

 
Unsubscribe headset registered 
-At standby mode 
-Press and hold SUB key enter the base’s registration mode with the “SUB” LED is flashlight 
-Press SUB key 7 times again the “SUB” LED is quick flash 
-All headsets registered to this part are cleared 
Note:    (1)SUB key A1orA2 to unsubscribe both A1 and A2. 

(2)SUB key A3orA4 to unsubscribe both A3 and A4. 
(3)SUB key B1orB2 to unsubscribe both B1 and B2. 
(4)SUB key B3orB4 to unsubscribe both B3 and B4. 

 
Conference talk 
When you are in a talk on the base, you can invite another channel headset to join your conversation.   
-Press the “All Conference” key on the base that you want to talk. 
-At the all conference mode, either wireless headset and four cord headset can conference. 
-Press the “All Conference” key on the base once again, turn off the all conference mode. 
 

This limited warranty only applies to the use of this device with a communications service for which it is designed.    This 

device alone does not provide the customer with any communications service and requires a separate subscription to a 

communications service from a service provider.  Altering service provider-specific settings may void the warranty.  

This limited warranty does not warrant that the device will be free of any limitations of voice quality or service caused by 

(1) the services provided by the customer’s underlying communications service provider; or (2) interference from other 

radio frequencies or transmissions, static electricity, and other electronic devices.   

 

This wireless headset is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits