Authinx Inc. AT15A ユーザーズマニュアル

3

2

1. Push open the battery

compartment on the
iParty Wireless Sender.

2. Insert the supplied

rechargeable battery.
Observe polarity.
Replace only with
NiMH “4/5 AAA”
1.2V, 400 mAh
rechargeable battery.

3. Attach your iPod Nano to the iParty

Wireless Sender by sliding it on to
the jack that fits into your iPod
Nano’s headphone socket.

5. Move the ON-OFF switch to ON.

4. Set the Channel Switch to

match the setting on your
Wireless Receiver.

Introduction
Send music from your iPod Nano to your stereo – without any wires. The iPod
Nano fits snugly into the iParty

®

 Wireless Sender and fits onto its headphone

jack. There’s a rechargeable battery in the iParty Wireless Sender (so it doesn’t
drain your iPod Nano’s battery). You can charge the battery by removing it
from the Sender and placing it in the compartment in the Receiver.

6. Set the Channel Switch to

match the setting on your
iParty Wireless Sender.

7. Connect the included plug-in

power supply to the Wireless
Receiver and plug the power
supply into an AC outlet near
your stereo

8. Attach the Wireless Receiver to your

stereo’s Audio or AUX input using
the supplied RCA audio cable.

9. Extend the antenna and point it in

the general direction that you
intend to listen to your music from.

Connecting up the Receiver
The Wireless Receiver connects to your Stereo Receiver, or any audio
component that has an Audio or AUX input. You can then sit back in your easy
chair, up to 50 ft. away from your stereo, and send your music from your iPod
nano to your stereo – without any wires!

iPod is a registered trademark of Apple Computer, Inc.

10. When the battery in your iParty Sender

goes flat, you can charge it by inserting it
into the compartment in the Receiver. Keep
a spare battery charging in the Receiver so
you can swap the batteries when the one in
your iParty Sender needs to be charged.
The battery should last about 3 hours.