Andrew Wireless Innovations Group RPT-MR701 ユーザーズマニュアル

User’s manual for Repeater MR801B Power

M0067A0A.doc

Id.-No 151111

Page 54

02-JUNE-99

Check alarms with ‘status hist‘ command.

1.  If a hardware module is damaged, replace corresponding hardware module.
2.  Minor alarms with no influence on the system can be cancelled by confirming the alarm

with the ‘alarmackn’ command, e.g., ALC active, VSWR, RSSI or DOOR OPEN.

3.  If all alarms have been acknowledged the summary error LEDs will be set back to green

indication.

4.  In case of mains power failure the contents of the actual STATUS HIST list is lost.

For a complete list of available alarms, see table 3-4 List of all available alarms

The output voltage is factory set and should not be changed.

•

 After a software download previous user settings ( data default values ) might be

overwritten. Before you start a software download save the set values for:

- 

centre frequency

- 

attenuation

- 

ALC threshold

•

 If an ALC or AMPBIAS alarm occurs during installation or commissioning an user error

might be the cause, due to wrong measurements.