Mitsubishi Electric Corp CP-D70DW ユーザーズマニュアル

  If, for some reason, printing is not possible or an error occurs during printing, the indicators on the front panel will   

illuminate or blink. In this case, follow the procedure described below.

 

In case of an error during printing, unless you turn off the unit, the unit resumes printing automatically when the error is 
corrected.

: Steady on   : Off  

: Blinking 

ALARM

PAPER RIBBON

POWER

Causes and Countermeasures

Page

(Orange)

This printer is in standby mode. 
Connect a USB cable to the printer when not 
connected.
It may take time that the printer is ready to print 
images after the image data is sent. 

7

 

(Green)

The printing unit is open.

• Close the printing unit.

7

 

 

(Green)

A paper jam occurs.

• Refer to “Overcoming paper jams.”

19

 

(Green)

The temperature of the thermal head is too high or 
too low.

• Wait until the indication goes off. When blinking 

stops, the printer resumes printing automatically.

7

 

(Green)

The ink ribbon which is not available to this printer 
is installed.

• Replace the ink ribbon with a new one.

The actual combination of ink ribbon and print 
paper is inconsistent with the setting made by the 
personal computer.

• Open the printing unit and confirm that the actual 

combination of ink ribbon and print paper is 
consistent with the setting made by the personal 
computer. After checking, close the printing unit.

14-15

(Green)

The print paper or ink ribbon is not installed.
The print paper or ink ribbon is used up.

• Install new print paper or ink ribbon.

11-12

(Green)

Other errors

20

When the ALARM or the PAPER RIBBON indicator illuminates or blinks, open the door and carry out the above 
countermeasures.