Zhejiang Flashforge 3D Technology CO. Ltd. CREATOR3 ユーザーズマニュアル
Creator3 User Guide | www.flashforge.com
400-699-1063
65
Method 2：Connect Via WiFi
①
Connect Creator3 with your PC under AP mode
a.Turn on your Creator3
b. Tap
b. Tap
[Tools]-[Setting]-[WLan hotspot]-[WLan hotspot ON]
.
c. Click on the wireless network setting in your computer, and find the wireless
signal-“
Creator3
”. Click
[Connect]
to connect your computer with Creator3 via Wlan
hotspot.
d. Click
[Print]-[Connect Machine]
on FlashPrint. Then the following dialog
box pops up. You need to select “Wi-Fi” in Connect Mode. Enter into the IP Address
shown on the interface and then click
shown on the interface and then click
[Connect]
.
If successfully connected, you will see the following mark on the right corner.
②
Connect Creator3 with your PC under STA mode
a. Tap
[Tools]
-
[Setting]
-
[WiFi]
-
[WiFi ON]
to turn on the WiFi of Creator3 and
connect your computer and Creator3 with the same WiFi signal.
b. Click
[Print]-[Connect Machine]
on FlashPrint. Then the following dialog
box pops up. You need to select “Wi-Fi” in Connect Mode. Enter into the IP Address
shown on the interface and then click
[Connect]
.