Taiwan New Innovation Co. Ltd. TZWR923 ユーザーズマニュアル

ページ / 15
Table of Contents
Section 
 
 
 
 
     
 
Page
I. Introduction / FCC Notice ..................................................
II. Safety ...............................................................................
III. Contents ..........................................................................
IV. Features and Descriptions ..............................................
V. Programming ...................................................................
VI. Installation ......................................................................
VII. Operation ......................................................................
VIII. Troubleshooting ...........................................................
Warranty and Contact Information ......................................
I. Introduction
Congratulations on the purchase of your new Champion
®
 WheelyBird™/Workhorse
®
 Wireless Remote.
This Champion
® 
 Wireless Remote is an optional accessory for use with Champion Workhorse and Post 2017 WheelyBird 
Traps with removable foot pedal.
Features of the Champion
®
 Wireless Remote Release system include:
* Battery powered hand-held remote, high impact plastic case
* Up to 120 yd transmission range
* Single Release system that will work with multiple receiver units
* User settable delay from 0-15 seconds
* Quick and easy installation
FCC NOTE:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not 
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired 
operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.  
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses 
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio 
communications.  However, there is no guarantee that interference will not occur in a particular installation.  If this equipment does cause harmful 
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the 
interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Shielded interface cable must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of 
FCC Rules.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate 
this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Radiation Exposure Statement:
The product complies with the FCC portable RF exposure limit set forth for an uncontrolled environment and is safe for the intended operation as 
described in this manual. Further RF exposure reduction can be achieved if the product can be kept as far as possible from the user ‘s body or when 
set to lower output power if such function is available.
Industry Canada Statement
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause 
interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
Radiation Exposure Statement:
This device complies with the Industry Canada portable RF exposure limit set forth for an uncontrolled environment and is safe for the intended 
operation as described in this manual. Further RF exposure reduction can be achieved if the product can be kept as far as possible from the user’s 
body or if the device is set to a lower output power if such function is available.
1
  
1
  2
  3
  4
  5
  5  
5
6
6
FCC ID:2ALBZTZWR923   /   IC:22547-TZWR923
40923_WirelessRemote_WheelybirdWorkhorse_2LIMv2.indd   2
9/26/17   11:29 AM