CORTEX TECHNOLOGIES CORPORATION CTCSP ユーザーズマニュアル
Buddee Smart Plug - User Instructions – SP-A-PH
Version 1.0 – June 2017 – © Cortex Technologies Corp – www.cortex.ph
Connecting the Smartplug
1) Remove the smartplug from its packaging.
2) Disconnect your Window Type AC unit from the wall
2) Disconnect your Window Type AC unit from the wall
power socket.
3) Plug the smart plug into the wall power socket, being
careful to align the prongs of the plug with the wall socket
correctly.
correctly.
4) Once the smart plug is connected to the wall socket it will
begin its start-up procedure.
5) During start up, the GREEN LED will flash once a second as
the smart plug attempts to connect to your home WIFI. As
WIFI hasn’t been configured yet (you do this using the
mobile app), after a short time the GREEN LED will turn
OFF and the RED LED will flash once a second to indicate
an internet connection could not be established. This is
normal. Proceed with the next section, unless you see any
other LED status, in which case refer to the LED status
section and troubleshooting guide for help on how to
proceed.
WIFI hasn’t been configured yet (you do this using the
mobile app), after a short time the GREEN LED will turn
OFF and the RED LED will flash once a second to indicate
an internet connection could not be established. This is
normal. Proceed with the next section, unless you see any
other LED status, in which case refer to the LED status
section and troubleshooting guide for help on how to
proceed.
6) Take the power cable from your Window Type AC unit and
connect it to the receptacle socket of the smart plug. Note
that now the electricity supply to your AC unit is now
controlled by the smart plug, and during start up sequence
the power supply is OFF.
that now the electricity supply to your AC unit is now
controlled by the smart plug, and during start up sequence
the power supply is OFF.
7) Proceed to the next section on “Installing the mobile
application”.