birde pty ltd BC02 ユーザーズマニュアル
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environ-
ment. End user must follow the specific operating instructions for satisfying RF exposure compliance.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter. The portable device is designed to meet the requirements for exposure to radio waves
established by the Federal Communications Commission (USA). These requirements set a SAR limit of
1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard
during product certification for use is 0.6W/kg when properly worn on the body
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environ-
ment. End user must follow the specific operating instructions for satisfying RF exposure compliance.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter. The portable device is designed to meet the requirements for exposure to radio waves
established by the Federal Communications Commission (USA). These requirements set a SAR limit of
1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard
during product certification for use is 0.6W/kg when properly worn on the body
FCC Part 18 Regulatory Information
This equipment has been tested and found to comply with the limits for a WPC device, pursuant to
Part 18 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the product.
NOTE: This equipment has been tested and found to comply with the limits for a wireless power
charger, pursuant to Part 18 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures: - Reorient or relocate the receiving antenna. - Increase the separation between
the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for
help.
This equipment has been tested and found to comply with the limits for a WPC device, pursuant to
Part 18 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the product.
NOTE: This equipment has been tested and found to comply with the limits for a wireless power
charger, pursuant to Part 18 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures: - Reorient or relocate the receiving antenna. - Increase the separation between
the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for
help.
Canada Industry Regulatory Information
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit
pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectri-
que subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit
pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectri-
que subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
RF Exposure
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environ-
ment. End user must follow the specific operating instructions for satisfying RF exposure compliance.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter. The portable device is designed to meet the requirements for exposure to radio waves
established by the ISED. These requirements set a SAR limit of 1.6 W/kg averaged over one gram of
tissue. The highest SAR value reported under this standard during product certification for use is
0.83W/kg when properly worn on the body.
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environ-
ment. End user must follow the specific operating instructions for satisfying RF exposure compliance.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter. The portable device is designed to meet the requirements for exposure to radio waves
established by the ISED. These requirements set a SAR limit of 1.6 W/kg averaged over one gram of
tissue. The highest SAR value reported under this standard during product certification for use is
0.83W/kg when properly worn on the body.
Cet équipement est conforme aux limites d’exposition aux rayonnements ISED établies pour un
environnement non contrôlé. L’utilisateur final doit suivre les instructions spécifiques pour satisfaire
les normes. Cet émetteur ne doit pas être co-implanté ou fonctionner en conjonction avec toute
autre antenne ou transmetteur. Le dispositif portatif est conçu pour répondre aux exigences
d’exposition aux ondes radio établie par le développement énergétique DURABLE. Ces exigences un
SAR limite de 1,6 W/kg en moyenne pour un gramme de tissu. La valeur SAR la plus élevée signalée
en vertu de cette norme lors de la certification de produit à utiliser est 0.83W/kg lorsqu’il est
correctement porté sur le corps.
environnement non contrôlé. L’utilisateur final doit suivre les instructions spécifiques pour satisfaire
les normes. Cet émetteur ne doit pas être co-implanté ou fonctionner en conjonction avec toute
autre antenne ou transmetteur. Le dispositif portatif est conçu pour répondre aux exigences
d’exposition aux ondes radio établie par le développement énergétique DURABLE. Ces exigences un
SAR limite de 1,6 W/kg en moyenne pour un gramme de tissu. La valeur SAR la plus élevée signalée
en vertu de cette norme lors de la certification de produit à utiliser est 0.83W/kg lorsqu’il est
correctement porté sur le corps.