KUANHAUR TECHNOLOGIES CO. LTD. DT821 ユーザーズマニュアル

寬豪科技股份有限公司

KUANHAUR TECHNOLOGIES CO., LTD.

1. Safety Precautions and Warnings

To prevent personal injury or damage to vehicles and/or the

scan tool, read this instruction manual first and observe the following

safety precautions at a minimum whenever working on a vehicle:

1. Always perform diagnosis or service in a safe environment.

2. Wear safety eye protection that meets ANSI standards.

3. Keep clothing, hair, hands, tools, test equipment, etc. away from all

moving or hot engine parts.

4. Operate the vehicle in a well ventilated work area: Exhaust gases are

poisonous.

5. Put blocks in front of the drive wheels and never leave the vehicle

unattended while running tests.

6. Use extreme caution when working around the ignition coil, distributor

cap, ignition wires and spark plugs.

7. These components create hazardous voltages when the engine is

running.

8. Keep a fire extinguisher suitable for gasoline/chemical/electrical fires

nearby.

9. Put the transmission in PARK (for automatic transmission) or

NEUTRAL (for manual transmission) and make sure the parking brake

is engaged.

10. Always turn the ignition off before connecting/disconnecting the OBDII

Cable to/from the TPMS tool; otherwise it may cause the Malfunction

Indicator Light (MIL) to turn on.

11. Refer to the user’s manual for the vehicle being serviced and adhere to

all diagnostic procedures and precautions. Otherwise personal injury or

unneeded repairs may result.

12. Keep the TPMS tool dry, clean, free from oil, water and grease.

13. Use a mild detergent on a clean cloth to clean the outside of the tool

when necessary