ParemTech PTLEVEL20R ユーザーズマニュアル

Place the receiver somewhere inside where there is a 

power outlet and WiFi signal.

Use a phone or 

tablet or PC to 

connect to 

PTLevel WiFi

Open a browser 

and enter in 

192.168.4.1 into 

the address bar

Select the 

strongest WiFi 

signal that has 

internet

Enter the 

password for the 

selected WiFi

Wait for the 

PTLevel to 

connect

When you see the 

screen below, 

you’re done! If not, 

try again or see 

troubleshooting.

Mount the transmitter onto the 

tank you would like to 

measure/monitor. Use screws or 

other means to mount it properly. 

Pic 1 is an example for a typical 

cistern.

PTLevel 

transmitter

Drill hole for 

tubing

Cistern

Pic 1

Below is an illustration on how to connect the pressure 

chamber using the provided clamp, bushing, and tube.

After the PTLevel is mounted, run the black tube through 

any necessary holes before proceeding to the next step.

Depending on the device you are using, find where you 

can see the list of available WiFi signals. If you need 

more help with this, see our YouTube videos.

Once the black tubing is fully connected and sealed 

tight, lower the pressure chamber into the liquid volume 

and allow it to lower to the bottom slowly. 

Note: Do not drop the chamber in an empty tank or it 

could break.

Note: You can cut the black tube shorter if you need, just 

pull it out of the liquid before you disconnect any of the 

tubing. 

Press the connect button on the side of the PTLevel 

transmitter. If the status LED blinks three times slowly, 

you are connected! See the troubleshooting on the other 

side if the LED does not blink three times slowly.

Visit www.ptdevices.com and select “Sign Up” if you 

don’t already have an account. Fill out the required 

inputs or click on a social login option for a simpler 

process.

If everything setup properly, you should see a level 

reading online. Press the connect button on the 

transmitter for a more recent reading.

After you have selected the “Add my device” button, you 

should see a “Waiting for device to connect” screen. If 

the PTLevel receiver is all setup properly, the waiting 

screen should disappear within a minute. If it does not, 

click on the “Remove this” and try adding it again. If it 

still does not work, try connecting the WiFi again.

Click on the “Please Setup” button near the level 

reading. Enter in the full depth of the tank and configure 

anything else. 

Once in your account, select “Add PTLevel” from the 

menu or “Connect It” from the dashboard. On the next 

screen, add the following ID of the PTLevel.

Note: Make sure all 

tubing connections 

are setup and 

sealed properly or 

the PTLevel will not 

read accurately.