Fusion Sport Proprietary Limited PT100 ユーザーズマニュアル

STEP 4 – SET UP YOUR GATES FOR TESTING

When set up correctly each gate should look like this –

TRIPOD ASSEMBLY

1.  Loosen tripod knob and pull legs away from stem.
2.  Push down on knob assembly until supports are horizontal.
3.  Extend Tripod to Desired height. We recommend extending one segment of the tripod to full extension
4.  Connect reflectors and remote data units and ensure tripod neck is firmly tightened.

ATTACHING THE TIMING GATE

1.  Line up the tripod connection with the bayonet the top of the tripod.
2.  Press down, into the tripod, and twist the timing unit into a locked position
3.  When ready, you may turn the unit on by pressing the power button, verify the unit turns on by viewing the

power LED on the back of the unit

ALIGNING YOUR TIMING GATES

1. Place the reflector tripod opposite the PT unit. The Reflector can be up to 5 meters away from the PT timing

unit.

2. Stand behind the PT Timing unit. Hold the unit with one hand, and the tripod neck with the other hand to

hold the tripod in place

3. Turn the PT unit on by pressing the power button
4. Adjust the beam until the red alignment light on the back of the unit is on. This can be done by aiming the

photocell and directional laser at the center of the reflector. Once aligned, the laser will stay illuminated for
an additional 5 seconds before turning off.

5. In windy environments, ensure the unit is remains aligned when wobbling the unit slightly side to side.