Jiangmen Honetian Technology Co. Ltd HTTTSTRM ユーザーズマニュアル
Remote Control Batteries:
The remote uses a CR2025 button cell battery (included). To
replace this battery when it is exhausted, follow these steps.
1. Slide out battery tray.
2. Remove old battery and replace with new battery. Be
certain that the battery is positioned so that the smooth side (+)
is towards the back of the remote.
3. Close battery tray and secure.
Mist – When the power button is turned on, the mist is
continuous. Press the mist button once to engage
intermittent mode, press again to turn mist off.
Light – Turns on the light. The color will slowly shift in a
Light – Turns on the light. The color will slowly shift in a
soothing pattern. A second press will freeze the color at
its current hue. Additional presses will cycle through a
range of colors that will not change. The pale color after
red is the shifting color mode. Hold for 3 seconds to turn
this feature off.
Brightness – Progressively dims the light. The third push
Brightness – Progressively dims the light. The third push
will restore full brightness.
Power – Turns the diffuser on or off.
Audio – Choice of two soothing tunes or two sets of
Power – Turns the diffuser on or off.
Audio – Choice of two soothing tunes or two sets of
nature sounds. Cycle through the options by pushing this
button. Hold for 3 seconds to turn this feature off.
Increase/Decrease Volume – Adjusts sound level.
Timer – Set the diffuser to shut off after 1, 3 or 6 hours.
Increase/Decrease Volume – Adjusts sound level.
Timer – Set the diffuser to shut off after 1, 3 or 6 hours.
An indicator light, visible when the ceramic shell is
removed, will indicate which mode is selected.
Note: The diffuser will shut down if the water is depleted
Note: The diffuser will shut down if the water is depleted
before the timer expires.
Functions
Use the remote to control the diffuser’s advanced features.
Contents:
Ultrasonic Diffuser
Power Adapter
Remote Control
3 Essential Oil Bottles
Basic Setup:
1. Plug the power cord into the power port on the bottom of the
diffuser.
2. Fill the tank with room temperature water. Do not fill past the
maximum fill line. Distilled water is recommended.
3. Add 4-5 drops of essential oils. Add more drops for a stronger
scent.
4. Put diffuser lid in place.
5. Place diffuser in desired location. Do not place anything on diffuser
or place diffuser under anything.
6. Plug adapter into power source, making sure that cable is not a
tripping hazard.
7. Press power button on the underside or use the remote (see
“Remote Control” on the following page).
8. Place decorative cover on diffuser.
• When the diffuser is turned on, colorful LEDs will cycle through a
spectrum of colors.
• Diffuser will automatically shut off when water level gets too low.
• After auto shut off, the lights and music can be turned back on
without refilling tank.
• Remember to remove the power cord when not in use.
Timer:
After the diffuser is turned on, pressing the power button will
activate one of the timer modes. Select 1, 3, or 6 hours.
Power
Indicator
Timer Mode
Indicator
1 / 3 / 6 hrs
Mist
Power
Timer
Light
Brightness
Decrease Volume
Increase Volume
Audio
ULTRASONIC DIFFUSER BLUETOOTH 360ml
Printed in China
Max Fill Line
Page 1