DIAS Automotive Electronic Systems Co. Ltd. TS211 ユーザーズマニュアル

 

 

13 

6.  TYRE INTERCHANGE SETTING INTRODUCTION 

Standard tyre pressure default value of this TPMS is 2.5Bar. The 

standard tyre pressure may be different for different concrete vehicle 

type. Users should set the standard tyre pressure according to specific 

vehicle type. The setting of standard tyre pressure needs to use special 

matching tool. Users can go to specified 4S shop or vehicle repair 

garage to do the settings.   

The purpose of tyre Interchange setting is to interchange left, right, 

front, rear tyre. This function facilitated the regular service to tyre. 

In order to avoid wrong operation, the setting methods and steps of 

TPMS to enter tyre interchange mode is as follows: 

①  Press “SET” without releasing. Then press “NEXT”. The two 

buttons is pressed together for 4s or more, then releases; 

②  Press “SET” again, the tyre interchange mode can exit. 

The tyre needed to change can be selected through pressing “T/P” 

for several times according to the change of tyre position in the 

display.  

For example: if the position of left rear tyre and right rear tyre 

position needs to change, the operation steps is as follows:   

①  Starting status as shown in figure 10; 
②  The tyre interchange setting mode enters according to operation 

steps mentioned above as shown in figure 11; 

③ 

The left rear tyre and right rear tyre is changed through pressing 

“T/P” for several times according to the change of tyre position 

in the display as shown in figure 12;