Thermor Ltd. 259RX ユーザーズマニュアル
Main Specification:
1. Indoor
temperature
2. Outdoor
temperature
3. Recorded daily highest and lowest temperature
4. Recorded highest and lowest temperature with date within 5 years
5. ℃/℉ switchable(Fault:℉)
6. Time
7. Calendar
8. Day of week
9. Low battery indicator
Before You Begin:
1.0 Set up procedure
1.0 Set up procedure
1. Insert batteries into the monitor first.
2. Place the monitor as close as possible next to the remote sensor and insert the batteries into the
remote sensor.
3. Position the monitor and remote sensor within effective transmission range, which in usual
circumstances no more than 45 meters. The range is affected by the building materials and where the
monitor and remote sensor are positioned; try various locations for the best results.
NOTE: The remote sensor should be placed in a shaded area for accurate readings
1.1 Getting Started
Once the remote sensor has been powered up, the monitor will attempt to search for the signal for 3
minutes.
Once the signal is received, the dashes (- -:-) on the monitor will change to the current outdoor
temperature. If after 3 minutes the screen does not change to show the outdoor temperature, press
“RE-SYNC” button in the monitor. The monitor will now attempt to search for the signal for another 3
minutes.
2.0 Troubleshooting
If monitor doesn’t receive the signal more than 2 minutes, your display shows dashes (- -:-). Press
“RE-SYNC” button in the monitor. The monitor will now attempt to search for the signal for another 3
minutes.
If monitor doesn’t receive the signal more than 60 minutes, the monitor will attempt to search for the
signal for another 3 minutes automatically.
If monitor doesn’t receive the signal all the time, the monitor will search for the signal for 3 minutes
every hour until signal received.
The maximum transmission range is 45 meters from the remote sensor to the monitor (in open space).
However, this depends on the surrounding environment and interference levels. The temperature
signal travels in a straight line from the remote sensor to the monitor. The signal will not curve around