Bose Corporation 412568 ユーザーズマニュアル
2.4GHz RF Modular Transceiver System
Installation manual (draft v1)
1.
Description
This document describes an RF transceiver module PCB having two independent
radio transceivers. One radio complies to IEEE 802.11b/g protocols and the other to
the Bluetooth Low Energy specification. The module provided on-board power
regulation and full shielding for the radio transceivers.
This document describes an RF transceiver module PCB having two independent
radio transceivers. One radio complies to IEEE 802.11b/g protocols and the other to
the Bluetooth Low Energy specification. The module provided on-board power
regulation and full shielding for the radio transceivers.
2.
The module consists of 2 separate circuits :
1) A 2.4GHz Wi-Fi RF transceiver IC and two PIF etch antennas.
2) A 2.4GHz Bluetooth Low Energy transceiver IC and one PIF etch antennas.
3.
Cautions:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved by
Bose Corporation
could void the
user's authority to operate this equipment.
WARNING! This module is to be installed only by Bose Corporation in its end products,
and shall not be marketed to any other party.
This RF Module has been certified for integration into products without further
certification. However, Bose Corporation is still responsible for testing its end products
for any additional compliance requirements required with this module installed (such as
digital device emissions, PC peripheral requirements, etc.).
and shall not be marketed to any other party.
This RF Module has been certified for integration into products without further
certification. However, Bose Corporation is still responsible for testing its end products
for any additional compliance requirements required with this module installed (such as
digital device emissions, PC peripheral requirements, etc.).