RadioShack Corporation 1200769 ユーザーズマニュアル
3
3
1
Connect the Transmitter
1.
Insert the transmitter’s power plug into your car’s power
outlet. The backlight turns on and the transmitter displays the
last used frequency.
2.
Insert the 30-pin connector into your iPod with the arrow
facing up. Your iPod will start charging.
n
Note: You may need to remove the protective case of the
iPod/iPhone to fully connect the FM transmitter.
2
Tune your Transmitter
Interference caused by your car’s antenna, design, and physical
location (such as under steel bridges and inside parking garages)
can prevent the transmitter from detecting frequencies and limit
sound quality. In these cases, you may need to select a saved
frequency, autoscan for a clear frequency, or manually tune a
frequency.
Auto-scanning for a Frequency
Hold down Scan until the display changes. Your FM transmitter
starts searching for about 30 seconds automatically and stops at a
clear frequency.
Manually Tuning a Frequency
1.
Hold down 2M until
M1
,
M2
, and
M3
all flash on the display.
2.
Press, but do not hold down 1or 3 to find the desired
frequency.
3.
Wait until the display stops flashing.
Saving Frequencies
To save the displayed frequency:
1.
Hold down 2M until
M1
,
M2
, and
M3
all flash on the display.