Motorola Solutions Inc. 89FT7622 ユーザーズマニュアル
Horizontally Polarized Modules
Product Note
Issue 1, April 2007
Page 5 of 18
1 Introduction
This product note covers the connectorized Canopy 5.7 GHz AP, including use under US FCC
regulations. Using a connectorized AP allows for a higher EIRP which often will translate into a
higher range for the sector, or a greater percentage of the SMs in the sector able to run at 2X.
regulations. Using a connectorized AP allows for a higher EIRP which often will translate into a
higher range for the sector, or a greater percentage of the SMs in the sector able to run at 2X.
See Section 2 for a complete list of available modules.
All modules are hardware series P10 running a minimum software release of Release 8.1.
Not all products are available in all regions or in all markets. If you have questions about
availability, please check with your Canopy distributor or reseller.
availability, please check with your Canopy distributor or reseller.
1.1
ABBREVIATIONS
The following abbreviations may be used in these notes:
BH
Backhaul Module, either timing master or timing slave
BHM
Backhaul Module – timing master
BHS
Backhaul Module – timing slave
AP
Access Point Module
SM
CNUT
CMM
DFS
MIB
P7/P8/P9/P10
ETSI
EIRP
Subscriber Module
Canopy Network Updater Tool
Cluster Management Module
Dynamic Frequency Selection for radar avoidance
Management Information Base
Shorthand for hardware series levels
European Telecommunications Standards Institute
Equivalent Isotropically Radiated Power
1.2
DOCUMENT CHANGE HISTORY
Issue 1
First Issue
1.3
FEEDBACK ON DOCUMENTATION
We welcome your feedback on Canopy documentation. Comments on structure, content,
accuracy, completeness, or any other area are appreciated. Please send your feedback to
accuracy, completeness, or any other area are appreciated. Please send your feedback to
technical-documentation@canopywireless.com
.