Motorola Solutions Inc. 99FT3096 ユーザーズマニュアル

 on page 109

The system connections are made through the Aux and/or Ethernet connectors on the bottom panel of
the SLR 1000 Repeater.

The positions of the Aux and Ethernet connectors are shown in 

See 

 for a description of the signaling that the Aux connector

supports.

 on page 109

Cable sealing glands or cordgrips are used to seal the openings in the bottom of the SLR 1000
Repeater when a cable is used with the repeater.

The RJ-45 cables for LAN and GPIO connections must be field terminated on at least one end to allow
the cables to be inserted through the cable gland. The cables are typically made to length on site in a
typical installation. Solid plugs are provided to seal the USB Programming connector and any unused
cable ports.

Prerequisites: Obtain a 1 in. torque wrench.

1 Insert unterminated data cable through the cable gland cap.

2 Insert unterminated data cable through the cable gland body.

3 Terminate the RJ-45 connector onto the cable and plug into the desired repeater connector.

4 Screw the cable gland body into the repeater opening. Torque to 55 in-lb.

5 Screw the cap to the cable gland. Torque to 55 in-lb.

6 If a cable gland is not used, seal the opening with a M20 threaded plug. Torque to 55 in-lb.

 on page 109

Equipment should be attached to a grounding bar using solid or stranded 6 AWG copper wires.

See the Motorola Solutions R56 manual Standards and Guidelines for Communication Sites (which
can be obtained by ordering CDROM 9880384V83) for more information on proper bonding and
grounding at a site.

MN003557A01-AF

Chapter 10:  SLR 1000 Installation

  115