Motorola Solutions Inc. MCSERIESHP10 External Photos
APPLICANT: MOTOROLA
EQUIPMENT TYPE: ABZMCSERIESHP10
November 23, 2010
To:
To:
Elite Electronic Engineering
Re: Identification
Change
for
iDEN Multi-Carrier– Dual Band – High Power Transmitter
Per CFR 47, Paragraph 2.933, Motorola respectfully requests a change in identification for the indicated
transmitter.
The affected transmitter is as follows:
Existing FCC ID
Lower (MHz)
Upper (MHz)
New FCC ID
PURMCSERIESHP10 851.0125
868.9875
ABZMCSERIESHP10
935.0187
939.9812
(1) The original identification used
The original identification used for the transmitter is PURMCSERIESHP10. This is a multi-carrier, dual band, high
power transmitter that is used in iDEN systems.
(2) The date of the original grant
The date of the original grant of equipment authorization is 03/27/2007.
(3) How the equipment bearing the modified identification differs from the original equipment
The change requested is in identification only. There is no change in design, circuitry, or construction of the unit
other than company logos and labeling. The front panels on the equipment have the Motorola logos rather than
the RadioFrame Networks logos. The identification label also contains ‘Motorola’ as well as the updated FCC
identification number, ABZMCSERIESHP10.
(4) Whether the original test results continue to be representative / applicable
All original test results currently on file with the commission are applicable and are representative of current and
future shipping product. The equipment will be completely compatible and interchangeable with the existing
equipment previously shipped by RFN. The form, fit, and function of the equipment is identical.
(5) Exterior appearance photographs
An image of the new label is shown below. The FCC ID label goes on the inside surface of the bulkhead at the
top of the rack. External photographs of the unit are shown on the following page.
LISTING NO: E112457
Model: MC Series High-Power FCC ID: ABZMCSERIESHP10
Electrical Requirements: Neg 48 VDC, 100 Amps
MADE IN MEXICO FABRIQUE AUX MEXICO
Certified to 47 CFR Part 90.691. Licensed operation required. APPROVED
Dimensions: This equipment complies with RF Exposure Limits for Fixed
Transmitters in accordance with 47 CFR Part 1.1310. This device
complies with part 15, class A of the FCC rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received
including interference that may cause undesired operation.