Arris WA840G ユーザーズマニュアル
INSTALLATION
SECTION 2
SECTION
2,
INSTALLATION
2-5
Be sure you print the template at 100% scale and that Fit to page is
not checked in the Print dialog box.
not checked in the Print dialog box.
3 Click OK to print the template.
4 Measure the printed template with a ruler to ensure that it is the
correct size.
5 Use a center punch to mark the center of the holes on the wall.
6 On the wall, locate the marks for the mounting holes you just
made.
WARNING!
Before drilling holes, check the structure for potential
damage to water, gas, or electric lines.
damage to water, gas, or electric lines.
7 Drill the holes to a depth of at least 3.8 cm (1½ inches).
8 If necessary, seat an anchor in each hole. Use M5 x 38 mm
(#10-16 x 1½ inch) screws with a flat underside and maximum
screw head diameter of 10.5 mm to mount the unit.
screw head diameter of 10.5 mm to mount the unit.
9 Using a screwdriver, turn each screw until part of it protrudes
from the wall, as shown:
!
There must be 4.0 mm (.16 inches) between the wall and the
underside of the screw head.
underside of the screw head.
!
The maximum distance from the wall to the top of the screw
head is 7.6 mm (.3 in).
head is 7.6 mm (.3 in).
4.0 mm
10.5 mm (.4 inches)
maximum
maximum
7.6 mm (.3 inches)
maximum
maximum
10 Remove the front two plastic feet, nearest to the LED panel, from
the bottom of the unit to uncover the keyholes.
11 Place the unit so the keyholes are above the mounting screws.
12 Slide the AP down until it stops against the top of the keyhole
opening.
13 Follow the installation procedures for connecting and configuring
the unit.