Arris WPS870G ユーザーズマニュアル
Enable
Check to enable; select the severity level.
Note: Currently, all traps are level 1.
Note: Currently, all traps are level 1.
For more information about using SNMP, see Chapter 7 - Special Features.
TCP/IP
Figure 31: TCP/IP Screen
IP Address
IP Address assigned to this device. If using dynamic IP Addresses
(DHCP, BOOTP, rarp), this should be left at 0.0.0.0.
(DHCP, BOOTP, rarp), this should be left at 0.0.0.0.
Subnet Mask
(Network Mask)
(Network Mask)
If the Router (Gateway) Address is 0.0.0.0, the Subnet Mask should
also be left at 0.0.0.0. If you have a router, enter the Subnet mask for
the segment to which the Wireless Print Server is attached.
also be left at 0.0.0.0. If you have a router, enter the Subnet mask for
the segment to which the Wireless Print Server is attached.
Gateway
Address
Address
If your network segment has a router or gateways, enter its IP
Address here. Otherwise, leave the address as 0.0.0.0.
Address here. Otherwise, leave the address as 0.0.0.0.
Connection
Delay before
reconnection
attempts
reconnection
attempts
Sets how long the Wireless Print Server should wait before retrying a
TCP/IP connection which is lost. Allowable values are from 0 to 255
seconds, with 2 as the default.
TCP/IP connection which is lost. Allowable values are from 0 to 255
seconds, with 2 as the default.
Number of
reconnection
attempts
reconnection
attempts
Set how many attempts at reconnection will be made. After that, the
TCP/IP session will be terminated.
Allowable values are from 0 to 255, with 254 as the default.
TCP/IP session will be terminated.
Allowable values are from 0 to 255, with 254 as the default.
Page 42