Furuno USA Inc 9ZWRTR104 ユーザーズマニュアル
14. MAINTENANCE, TROUBLESHOOTING
14-4
14.4.4
Fish finder troubleshooting
Problem
Remedy
You selected a fish finder dis-
play, but no picture appears.
play, but no picture appears.
• Check that the transducer cable is fastened.
• Check that the fish finder source is correct.
• If you are using a network fish finder, check that it is properly
• Check that the fish finder source is correct.
• If you are using a network fish finder, check that it is properly
connected.
Marks and characters appear,
but no picture appears.
but no picture appears.
Check if the transducer cable is connected.
Picture appears but zero line
does not appear.
does not appear.
• The picture is shifted. Check the shift setting.
• Check if draft is set to zero or higher.
• Check if draft is set to zero or higher.
The picture sensitivity is too
low.
low.
• If you are in the manual mode, check the gain setting.
• Check the transducer face for marine life or air bubbles.
• Bottom is too soft to return an acceptable echo.
• Check the transducer face for marine life or air bubbles.
• Bottom is too soft to return an acceptable echo.
The depth indication does not
appear.
appear.
• For manual operation, adjust gain and range to display the bot-
tom echo (in reddish-brown).
• Adjust bottom level HF/LF.
Noise or interference shows on
the display.
the display.
• Make sure the transducer cable is not near the engine.
• Check the ground.
• Check if another fish finder in the vicinity of your boat has the
• Check the ground.
• Check if another fish finder in the vicinity of your boat has the
same frequency as your fish finder.
• Try to reject the interference with [Interference Rejection] in the
[Settings] - [Sounder] menu.