ICOM 272105 ユーザーズマニュアル

24

4

BIIS OPERATION

D

D Programming an SDM memory

(10-keypad version is required)

q During standby condition, push [P1] (Digital) twice, then

push [UP] or [DOWN] to select the desired SDM to be edit-
ed.

w Push [M] or [#] to enter the message editing condition.

• The first character blinks when [#] is pushed, the last character

blinks when [

M

] is pushed as below.

e Push the appropriate digit key, [0] to [9], to enter the

desired character.

• See the table at right for the available characters.
• Pushing [UP] also enters space, pushing [DOWN] deletes the

selected character.

r Push [#] to move the cursor to the right, push [M] to move

the cursor to the left.

t Repeat steps e and r to set the desired text message.
y Push [P1] (Digital) for 1 sec. to overwrite the set content

into the memory.

• Push [P1] (Digital) momentarily to cancel the editing and return to

the original message indication.

NOTE: Once the pre-programmed character including a
decimal point is rewrote with the 10-keypad, the decimal
point cannot be displayed again.

[0]

[1]

[2]

[3]

[4]

[5]

[6]

[7]

[8]

[9]

(0)

(1)

(2)

(3)

(4)

(5)

(6)

(7)

(8)

(9)

(.)

(Space)

(A)

(D)

(G)

(J)

(M)

(P)

(T)

(W)

(!)

(#)

(B)

(E)

(H)

(K)

(N)

(Q)

(U)

(X)

(?)

(✱)

(C)

(F)

(I)

(L)

(O)

(R)

(V)

(Y)

(’)

(/)

(a)

(d)

(g)

(j)

(m)

(S)

(t)

(Z)

(")

(+)

(b)

(e)

(h)

(k)

(n)

(p)

(u)

(w)

(,)

(—)

(c)

(f)

(i)

(l)

(o)

(q)

(v)

(x)

(;)

(=)

(r)

(y)

(:)

(_)

(()

())

(<)

(>)

([)

(])

(/)

(&)

(%)

($)

(@)

(^)

(s)

(z)

IC-F43GT_GS.qxd  04.4.9 1:10 PM  Page 24 (1,1)