ICOM 285200 ユーザーズマニュアル
7
3
BASIC OPERATION
New2001
3
■ Receiving and transmitting
CAUTION:
Transmitting without an antenna may dam-
age the transceiver.
q Push [VOL] for 1 sec. to turn power ON.
w Set the audio and squelch levels.
w Set the audio and squelch levels.
➥ Rotate [SQL] fully counterclockwise in advance.
➥ Rotate [VOL] to adjust the audio output level.
➥ Rotate [SQL] clockwise until the noise disappears.
e To change the channel group, push both [Y] and [Z] on
the transceiver. (p. 6)
r Push [Y] or [Z] to select the desired channel. (p. 6)
• When receiving a signal, “
” appears and audio is emitted
from the speaker.
• Further adjustment of [VOL] may be necessary.
t Push [LO/DX•
IC
] to turn the receive attenuator function
ON or OFF, if necessary.
• “
” appears when the receive attenuator function is in use.
y Push [HI/LO] to select the output power if necessary.
• “LOW” appears when low power is selected.
• Choose low power for short range communications, choose high
• Choose low power for short range communications, choose high
power for longer distance communications.
• Some channels are for low power only.
u Push and hold [PTT] to transmit, then speak into the mi-
crophone (M).
• “
” appears.
• Channel 70 cannot be used for transmission other than DSC.
i Release [PTT] to receive.
Simplex channels, 3, 21, 23, 61, 64, 81, 82 and 83 CAN-
NOT be lawfully used by the general public in U.S.A. wa-
ters.
NOT be lawfully used by the general public in U.S.A. wa-
ters.
IMPORTANT: To maximize the readability of your trans-
mitted signal, pause a few sec. after pushing [PTT], hold
the microphone 2 to 4 inches (5 to 10 cm) from your mouth
and speak into the microphone (M) at a normal voice level.
mitted signal, pause a few sec. after pushing [PTT], hold
the microphone 2 to 4 inches (5 to 10 cm) from your mouth
and speak into the microphone (M) at a normal voice level.
i
r
y
M
u
q
M: Microphone
w
r
t
e
!IC-M422_FCC.qxd 05.1.14 11:30 AM Page 7 (1,1)