ICOM 325300 ユーザーズマニュアル
43
7
SCAN OPERATION
N Scan edges programming
Scan edges can be programmed in the same manner as
memory channels. Scan edges are programmed into scan
edges, 0A/0b to 24A/24b, in memory channels.
memory channels. Scan edges are programmed into scan
edges, 0A/0b to 24A/24b, in memory channels.
qPush [V/M/C] to select the VFO mode.
wSet a desired frequency:
± Select a desired band with [BAND].
± Set a desired frequency with [DIAL].
± Program different frequencies in “1A” and “1b” respec-
± Set a desired frequency with [DIAL].
± Program different frequencies in “1A” and “1b” respec-
tively.
± Set other data
(e.g. frequency offset, duplex direction, tone
squelch, etc.)
, if desired.
e Push and hold [S.MW](V/M/C) for 1 sec. to enter the select
memory write mode.
• 1 short and 1 long beep sound.
• “
• “
” icon and memory channel number blink.
r Rotate [DIAL] to select a desired programmed scan edge
channel from 0A to 24A.
tPush and hold [S.MW](V/M/C) for 1 sec.
• 3 beeps sound
.
• The other scan edge channel “b,” 0b to 24b, is automatically se-
lected when continuing to push [S.MW](V/M/C) after program-
ming.
ming.
y To program a frequency for the other pair of scan edges,
0b to 24b, repeat steps
w and r.
• If the same frequency is programmed into a pair of scan edges,
programmed scan will not function.
[DIAL]
The VFO mode
Enter
the select memory write mode.
the select memory write mode.
to select
Rotate
Push and hold
for 1 sec.
for 1 sec.
“3A.”
“3A” is selected.
Return to the VFO mode.
Push and hold
for 1 sec.
for 1 sec.
[EXAMPLE]: Programming 145.300 MHz into scan edges 3A.