ICOM 325300 ユーザーズマニュアル

75

10

OTHER FUNCTIONS

N Resetting

The display may occasionally display 
erroneous information (e.g. when first 
applying power). This may be caused 
externally by static electricity or by 
other factors.

If this problem occurs, turn power OFF. 
After waiting a few seconds, turn power 
ON again. If the problem persists, per-
form either or both procedures below.

Reset the CPU before operating the 
transceiver for the first time, or if the 
internal CPU malfunctions due to static 
electricity, etc. All reset clears all pro-
gramming and returns all settings to 
their factory defaults. 

Use Partial reset if you want to initial-
ize the operating conditions (VFO 
frequency, VFO settings, set mode 
contents) without clearing the memory 
contents.

D All reset

q   Push and hold [ ] for 1 sec. to turn 

power OFF.

w   While continuing to push [SET],

[BAND] and [H/M/L], then tur n 
power ON to reset the CPU.

• “CLEAR” appears when resetting the 

CPU (See the illustration below).

CAUTION:  Resetting the CPU re-
turns all programmed contents to 
their default settings.

D Partial reset

q   Push and hold [ ] for 1 sec. to turn 

power OFF.

w   While continuing to push [V/M/C], 

then tur n power ON to par tially 
reset the transceiver.

NOTE: No message appears on the 
display after the partial reset is done.