ICOM 348400 ユーザーズマニュアル

New2001

D-STAR OPERATION

D-ST

AR OPERA

TION

PROBLEM

POSSIBLE CAUSE

SOLUTION

REF.

After your call, the repeater re-
plies ‘RPT?’ and call sign of the
destination repeater.

• The repeater cannot connect to the destina

tion repeater.

• The repeater is busy.

• Check the repeater setting.

• Wait for a while, and try it again.

p. ?

—

After your call, the access re-
peater replies ‘RPT?’ and its call
sign.

• The call sign of the destination repeater is

wrong.

• Correctly set the destination repeater call

sign.

p. ?

Even holding down [DR], the DR
screen will not appear.

• There is no repeater list in your radio.

• Reload the repeater list using the SD card.
• Enter the Repeater list data directly into the

transceiver.

p. ?
Section 7 of the
Full Instruction

Even holding down [RX>CS], the
received call sign will not set to
the destination call sign.

• The call sign has not been correctly re

ceived.

• When a received signal is weak, or a signal

is received during scanning, the call sign
may not be received correctly. In that case,
“--------” appears and error beeps sound,
and a reply call cannot be made.

• Try it again, after the transceiver has cor

rectly received the call sign.

—

A Local area call can be made,
but the Gateway call or destina-
tion station call cannot be made.

• MY call sign has not been registered at a

D-STAR repeater.

• Register your call sign (MY) on a D-STAR

repeater, or confirm the registration of the
call sign.

p. ?

“L” appears on the LCD, and the
received audio is interrupted.

• While receiving through the internet, some

packets may be lost due to a network error
(poor data throughput performance).

• Wait a while, and try it again.

When the transceiver receives corrupted

data, and misidentifies it is as packet loss,
“L” is displayed, even if it is a Local area
call.

—

“DV” and “FM” icons alternately
blink.

• While in the DV mode, an FM signal is re

ceived.

• Wait a while, and try it again.

p. ?