ICOM AP-3 ユーザーズマニュアル
SETTING SCREENS
8
55
8-3 [Routing Settings] Screen
■
RIP setting
When RIP is used, the AP-3 exchanges routing informa-
tion with nearby routers and access points to dynamical-
ly create a communication path. RIP packets are broad-
cast approximately every 30 seconds using the broadcast
addresses of those routers and access points.
tion with nearby routers and access points to dynamical-
ly create a communication path. RIP packets are broad-
cast approximately every 30 seconds using the broadcast
addresses of those routers and access points.
(default value: Yes)
A setting change will not take effect until the AP-3 unit is
restarted.
restarted.
■
IP routing
information
information
This table displays information regarding which terminal,
access point, or router the packet should be distributed to
when the AP-3 transmits a packet. Paths added using the
[Static Routing Settings] (
access point, or router the packet should be distributed to
when the AP-3 transmits a packet. Paths added using the
[Static Routing Settings] (
☞
p. 57) are also displayed
here.
q
w
e
r
t
y
q
Destination ···············
This column shows the destination IP address of the
packet being routed.
packet being routed.
w
Net Mask···················
This column shows the net mask corresponding to the
destination IP address of the packet being routed.
destination IP address of the packet being routed.
e
Gateway····················
This column shows the gateway corresponding to the
destination IP address of the packet being routed.
destination IP address of the packet being routed.
·············································Continued on following page