ICOM AP-3 ユーザーズマニュアル
UTILITY SOFTWARE
12
69
Î
Operate the utility
The procedures for operating the [AP-3 Utility] screen
are explained below. Encircled numbers refer to the
reference numbers shown in the screen shot on page
68.
are explained below. Encircled numbers refer to the
reference numbers shown in the screen shot on page
68.
[EXTREMELY IMPORTANT]
Never turn off the power to the AP-3 unit while it is
restarting after initializing the user data (setting
data) or updating the firmware (
Never turn off the power to the AP-3 unit while it is
restarting after initializing the user data (setting
data) or updating the firmware (
☞
p. 70 and 71).
If the power is turned off before the restart process
is completed, the data in the AP-3 unit will be lost
and the AP-3 will no longer function.
After “Processing completed. Restarting system...” is
displayed in area
is completed, the data in the AP-3 unit will be lost
and the AP-3 will no longer function.
After “Processing completed. Restarting system...” is
displayed in area
u
of the [AP-3 Utility] screen, wait
until the lamps on the front panel return to the state they
were in before the restart process began.
were in before the restart process began.
Î
-1 Initializing the
setting data
[Scope of initialization]
When the initialization is executed from the Utility, all set-
ting data are initialized.
[Procedure]
1. Enter the IP address of the AP-3 unit in the [AP-3 IP
When the initialization is executed from the Utility, all set-
ting data are initialized.
[Procedure]
1. Enter the IP address of the AP-3 unit in the [AP-3 IP
Address
q
] text box.
(default value: 192.168.0.1)
2. Click the radio button next to [Initialize User Data]
under [Function
w
].
3. Click the <Execute
t
> button.
• The status of the initialization is indicated in the area
u
at the bottom of the screen. During restart, all front
panel lamps will be illuminated. When restart is com-
pleted, the lamps will return to their original state (i.e.,
how they were before the initialization was executed).
pleted, the lamps will return to their original state (i.e.,
how they were before the initialization was executed).
* The message “AP-3 not found” will be displayed if
communication between the setting terminal and the
AP-3 unit fails. Check the following:
• Is the AP-3 unit in [Update Mode] (
AP-3 unit fails. Check the following:
• Is the AP-3 unit in [Update Mode] (
☞
p. 68)?
• Did you enter the correct AP-3 IP address (
☞
p. 42)
into the [AP-3 IP Address
q
] textbox?
4. Close the Utility.